PRODUCT

​​FORUM™ - FORUM™ SYNTHETIC 

FORUM™ SYNTHETIC is a high-quality product designed to protect, conserve resources, and restore the friction surfaces of all types of four-stroke engines.

It is compatible with all types of base oils. The foundation of all FORUM™ additives is the ultrafine powder of polytetrafluoroethylene (UPTFE-FORUM™), which is composed of various temperature grades.

All additives contain a mixture of these grades, with synthetic FORUM™ being the only one with high-temperature resistance. The high-temperature fraction is obtained under the harshest conditions, resulting in the most wear-resistant layer.

Additionally, this product is made from Group IV base oil.

All these characteristics provide higher efficiency in additive applications.

FORUM™ SYNTHETIC is used for turbocharged engines.

The presence of a turbocharger enhances the efficiency of the additive, as the UPTFE-FORUM™ coating can withstand high temperatures (up to 400°C and briefly up to 500°C) and adheres firmly to the friction surfaces, greatly reducing wear and the possibility of turbocharger failure, especially during startup and in the absence of oil film.

Effects of using synthetic FORUM™:

  • Maximizes protection of working surfaces against friction and wear, especially under high temperatures and high mechanical loads.

  • Reduces the friction coefficient in the oil by 20% and decreases it by 100 times in the absence of oil film.

  • Increases engine power by 30%.

  • Reduces surface wear by 5-15 times.

  • Reduces noise and vibrations by 2-8 dB.

  • Saves up to 20% on fuel consumption.

  • Quickly restores damaged surfaces.

  • Extends the lifespan of the engine oil by 2-3 times.

  • Increases compression in the cylinders.

  • Eliminates wear during cold starts.


Composition: High-temperature fraction of UPTFE-FORUM™ and Group IV polyalphaolefin (PAO) base oil.

To add synthetic FORUM™, follow the following procedure for oil change and oil filter replacement: 

1. Drain the old engine oil and replace the oil filter.

2. Shake the small bottle vigorously until the active ingredients of UPTFE-FORUM™ are evenly distributed throughout the liquid volume.

3. Pour the additive into a container with the new oil and stir. It is normal to have a small amount of sediment at the bottom of the empty bottle after use. 

4. Pour the oil with the additive into the engine and let it run for at least 15 minutes to ensure the additive is evenly distributed throughout the system. It is recommended to use synthetic FORUM™ with every oil change. One bottle is suitable for 3-7 liters of oil.

If it is not possible to add FORUM™ SYNTHETIC during the oil change and filter replacement simultaneously, it can be done before driving 500 kilometers. In this case, the additive must be poured into the running engine through the oil filler cap for 5 minutes or in 2-3 consecutive injections with engine off and restarting for 5 minutes after each addition.

The effects of the additive application will manifest after driving 200-500 kilometers and will increase in effectiveness and persist throughout the entire oil usage period.