PRODUCT

FORUM-500 is designed for any four-stroke engine in trucks, minibusses, vans, and construction equipment with oil capacity of 20-30 liters.

The impact of using FORUM-500 additive in 20-30 liters of oil for a four-stroke engine includes:

• Protection of engine components from friction and wear.

• Reduction of surface wear by 2-10 times.

• Halving of carbon formation and reducing vibrations by 2-8 decibels.

• Extension of oil life by 2-3 times.

• Elimination of wear during cold starts.

• Elimination of heating and wear caused by friction vapor, even in the absence of oil.

• Doubling the overhaul period.

• Increase in engine power by 6%.

• Increase in cylinder compression.

• Savings of up to 10% on fuel consumption.

Ingredients: UPTFE-FORUM™ and deep cleaning base oil.

To use FORUM-500, the following procedure must be followed after replacing the oil filter:

1. Drain the old engine oil and replace the oil filter.
2. Shake the small bottle vigorously until the active components of UPTFE-FORUM™ are distributed throughout the liquid volume.
3. Pour the additive into a container with fresh oil and stir. A small amount of sediment at the bottom of the empty bottle after use is normal.
4. Pour the oil with the additive into the engine and run the engine for at least 30 minutes to ensure even distribution of the additive throughout the system.
One bottle (500 milliliters) is designed for 20-30 liters of oil.