PRODUCT

​​FORUM™ - FORUM™ for all types of four-stroke engines

FORUM™ is designed to protect all types of four-stroke engines with a maximum displacement of 2.5 liters or mileage less than 100,000 kilometers.


FORUM™ for four-stroke engines contains the active ingredient UPTFE-FORUM™ at a standard concentration and is produced on a base of deep-cleaning base oil. It is recommended for vehicles with low mileage or smaller engine sizes.


FORUM™ for four-stroke engines is also suitable for turbocharged engines. The presence of a turbocharger enhances the efficiency of the additive because the UPTFE-FORUM™ coating can withstand high temperatures (up to 400°C and transient peaks of up to 500°C) and remains firmly bonded to the friction surfaces. This significantly reduces wear and the risk of turbocharger failure, especially during startup and in situations where lubrication oil is insufficient.

The application effects of FORUM™ additive in four-stroke engines include:

  • Protection of engine components against friction and wear

  • Extended service life of the oil by 2-3 times

  • Restoration of damaged surfaces

  • Reduction of vibration and carbon formation

  • Increased cylinder compression and engine power by up to 6%

  • Elimination of wear during cold starts

  • Fuel savings of up to 10%


Ingredients: UPTFE-FORUM™, deep-cleaning base oil


When replacing the engine oil according to the following procedure, use a clean oil filter:

1. Drain the old engine oil and replace the oil filter.
2. Shake the bottle vigorously until the active ingredient UPTFE-FORUM™ is evenly distributed throughout the liquid volume.
3. Pour the additive into a container with new oil and stir. It is normal to have a small amount of sediment at the bottom of the empty bottle after use.
4. Pour the oil with the additive into the engine and run it for at least 30 minutes to ensure even distribution of the additive throughout the system.


It is recommended to use FORUM™ with every oil change. One bottle is designed for 2-5 liters of oil.

If it is not possible to add FORUM™ simultaneously during oil and filter replacement, it can be done before driving 500 kilometers. In this case, the additive must be poured into the running engine through the oil filling port for 5 minutes or in 2-3 portions, with the engine being restarted for 5 minutes after each addition.
The effects of the additive will become apparent after driving 200-500 kilometers and will continue throughout the entire service life of the oil.