PRODUCT

​​FORUM™ Super is suitable for all four-stroke engines.


SUPER FORUM™ is designed to protect all types of four-stroke engines, including engines with a displacement exceeding 2.5 liters or mileage over 100,000 kilometers.

SUPER FORUM™ for four-stroke engines contains a higher concentration of the active ingredient UPTFE-FORUM™ and is produced on a deep-cleaning base oil. It is recommended for high-mileage or large-capacity engines.

SUPER FORUM™ for four-stroke engines is also suitable for turbocharged engines. The presence of a turbocharger enhances the efficiency of the additive, as the UPTFE-FORUM™ coating can withstand high temperatures (up to 400°C and briefly up to 500°C) and adheres firmly to the friction surfaces, greatly reducing wear and the possibility of turbocharger failure, especially during startup and in the absence of oil film.

Effects of SUPER FORUM™ additive on four-stroke engines:

  • Protects engine components against friction and wear.

  • Extends the lifespan of the oil by 3 times.

  • Restores damaged surfaces.

  • Reduces vibrations and carbon formation.

  • Increases compression in the cylinders and boosts engine power by up to 10%.

  • Eliminates wear during cold starts.

  • Saves up to 15% on fuel consumption.

​Composition: UPTFE-FORUM™, deep-cleaning base oil.


When replacing the engine oil in an engine with a clean oil filter, SUPER FORUM™ is used according to the following procedure:
1. Drain the old engine oil and replace the oil filter.
2. Shake the small bottle vigorously until the active ingredients of UPTFE-FORUM™ are evenly distributed throughout the liquid volume.
3. Pour the additive into a container with the new oil and stir. It is normal to have a small amount of sediment at the bottom of the empty bottle after use.
4. Pour the oil with the additive into the engine and let it run for at least 30 minutes to ensure the additive is evenly distributed throughout the system.

One bottle is designed for 5-8 liters of oil. After applying SUPER FORUM™, it is sufficient to treat the engine with the additive once, and with the next oil change, FORUM™ treatment for four-stroke engines is enough.

If it is not possible to add FORUM™ additive during the oil change and filter replacement simultaneously, it can be done before driving 500 kilometers. In this case, the FORUM™ additive must be poured into the running engine through the oil filler cap for 5 minutes or in 2-3 consecutive injections with the engine off and restarting for 5 minutes after each addition.

The effects of the additive application will be noticeable after driving 200-500 kilometers and will increase and persist throughout the entire lifespan of the oil.